Wireless flash synchronization remote controller

Wireless flash synchronization controller YN-16TM

Functions of remote control1.First turn off the camera power supply2.Connect the receiver plugs with the camera,and turn on their

power3.Press the transmitter's button,when the indicator light and the

receiver indicator light flashes ont the same,work can carry out.4.Bulb shutter,first set the camera to Bulb,long press the

transmitter button until the res light gose out(about 3S),then the

receiver atuomatically turn to Bulb shutter state,if need to th

out of Bulb shutter,just press the transmitter button again.5.When the flash is sleeping,half-press the button on the

transimitter to wake it up,and turn to normal working conditon.6.Continuous Capture Modes,first set the camera to Continuous

Capture Modes,long press the transimitter button until the red

light goes out(about 3S),then the receiver atuomatically turn to

Continuous Capture Modes,and if need to leave Continuous Capture

Modes,just press the transmitter button again.

Function of flash trigger.1.Inset the flash to hot shoe outlet of receiver,turn on the power

(long press for 1 second)Insert the transmitter to camera hot shoe,turn on camera power

supply and halfway press its shutter,then the blue lights of the

transmitter and receiver will bright for several seconds,so that

the connection is correct,you can shoot normally.2.The controller supports Nikon,Canon flash wake-up function.Multi receivers can be used to support the citation a number of

flashes at the same time,and realize the creative lighting.Set the transmitter channels correspond to receiver,if the

transmitter is set to (1234),it can control the receiver of any

channel in its control region.In order to avoid the interference

of this remote control with others,please set the transmitter and

receiver to the same channe.You can use one transmitter to control

multiple receivers at the same time.

Wireless flash synchronization remote controller